Custom Math Waveforms using Matlab and ADK on an Oscilloscope


Custom Math Waveforms using Matlab and ADK on an Oscilloscope


The following is a list of equipment and software that is needed to do this quick MATLAB example. In the download below there is a txt file that has the instruction with where to place the MATLAB file and ADK files. 

Equipment list:

  • Windows 7 oscilloscope with firmware version 6.4 or later
  • MATLAB with the Instrument Control Toolbox or any other toolboxes you will use (e.g. Signal Processing Toolbox).


This example will show you how to update a txt file using the Application Development Kit (ADK) with values for your cutoff frequency. Then using a custom MATLAB filter file it will read in the values from this txt file and apply the appropriate butter worth 3rd order filter with corresponding cutoff frequencies. 


Download File (5.76 KB)

This FAQ Applies to:

Product Series: MSO/DPO70000, MSO5000 / DPO5000, DPO7000

Applications: Using MATLAB with Tektronix Instruments

Product: MSO70404C, MSO70604C, MSO70804C, MSO71254, MSO71254C, MSO71604, MSO71604C, MSO72004, MSO72004C, DPO5054, DPO5104, DPO5204, DPO70404C, DPO7054C, DPO70604C, DPO70804C, DPO7104C, DPO71254C, DPO71604C, DPO72004C, DPO72504D, DPO7254C, DPO73304D, DPO7354C, DSA70404C, DSA70604C, DSA70804C, DSA71254C, DSA71604C, DSA72004C, DSA72504D, DSA73304D

FAQ ID : 64766

View all FAQs »

Laden Sie Handbücher, Datenblätter, Software und vieles mehr herunter:

Go to top