DE
Aktueller Standort
×
DE

Wählen Sie Region, um Ihr Erlebnis anzupassen:

Menü umschalten
DE
Aktueller Standort
×
DE

Wählen Sie Region, um Ihr Erlebnis anzupassen:

Kontaktaufnahme

Live-Chat mit Tektronix-Vertretern. Verfügbar von 09:00 - 17:00 Uhr CET.

Anrufen

Kontaktieren Sie uns telefonisch unter

Verfügbar von 9:00 bis 17:00 Uhr CET Geschäftstage

Download

Laden Sie Handbücher, Datenblätter, Software und vieles mehr herunter:

DOWNLOADTYP
MODELL ODER SCHLÜSSELWORT

Floating Oscilloscope Measurements ... And Operator Protection


Oscilloscope users often need to make "floating" measurements where neither point of the measurement is at ground (earth) potential. "Signal common" may be elevated to hundreds of volts from earth. In addition, many of these measurements require the rejection of high common-mode signals1 in order to evaluate low-level signals. Unwanted ground currents can also add bothersome hum and ground loops. Too often, users resort to the use of potentially dangerous measurement techniques to overcome these problems.

  • Limitations of Traditional Oscilloscopes
  • Management and Safety in the Workplace
  • Floating an Oscilloscope: A Definition
  • Safety Engineering Principles
  • Safety - A Shared Responsibility
  • Battery-Powered Oscilloscopes
  • Monolithic Isolation Amplifiers
  • Differential Management System
  • Isolated-Input Oscilloscope

1 A "common-mode signal" is defined as a signal which is present at both points in a circuit. Typically referenced to ground, it's identical in amplitude, frequency, and phase. Making a floating measurement between two points requires rejecting the "common-mode signal" so the difference signal can be displayed.